Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Fast, Reliable Roof Replacement Across Compton
Roof replacement in Compton, CA typically runs $9,800 to $18,500 for a standard single-story stucco ranch with architectural shingles, and most jobs finish in 3 to 6 days once materials are staged. That’s the honest range we quote for the 1940s to 1960s tract homes that make up most of this city’s housing stock. If you’re in 90221 or 90222 and watching old mineral-surface shingles curl at the drip edge after decades of South Bay sun, call (855) 597-2817 for a free estimate. We run our own crews out of Downey, which puts us about 15 minutes from most Compton neighborhoods without the markup you’d pay a contractor hauling in from Orange County.
Why Seacrest Roofing Is Compton’s Preferred Roof Replacement Company
Noel Chambers built Seacrest Roofing around a repair-first philosophy, and that’s exactly the lens we bring to every Compton roof we walk. We’re not the crew that shows up already planning to sell you a full tear-off. We diagnose first. Sometimes that means patching a sun-cracked eave and resealing a stucco parapet, which costs a few hundred dollars and buys you two more years. Sometimes it means the decking is gone and the fascia is wicking water, and replacement is the honest call.
What sets us apart in Compton specifically is our manufacturer-agnostic material position. Most roofing contractors in the South Bay push a single shingle brand because that’s what their supply agreement demands. We stock and install across seven manufacturers: GAF, CertainTeed, Owens Corning, IKO, Atlas, Tamko, and Boral. So when we recommend a shingle for your Juniper Street ranch or your apartment building off Long Beach Boulevard, it’s because the material matches your roof slope, exposure, and budget. Not because we have a quota to hit.
Compton homeowners consistently tell us the same thing: they wanted real options, not a one-brand pitch. We give you a written line-item quote, pull permits through the city, and run every inspection and replacement under the same team. No handoffs. No “who’s actually doing the work” guesswork.
Styles & brands we work with
Flat Roof Replacement in Compton
Flat roof replacement in Compton usually runs $7,200 to $14,000 depending on square footage, deck condition, and whether we’re pulling up old torch-down or going over a clean substrate. Your first sentence of this section is answered: we handle flat roofing on the 1960s and 70s low-rise stucco apartment buildings scattered throughout 90220 and 90221, plus the occasional modified-bitumen section on older tract homes where a carport or addition was built with minimal pitch. The real question is always what’s underneath the old membrane.
What Flat Roof Work Involves Here
A Compton flat roof takes punishment differently than a pitched one. No tree canopy means direct UV all summer, which dries out modified-bitumen and causes it to check and crack at seams and flashings. We strip the old membrane, dry out any saturated insulation, repair the decking, then install a new system with sealed seams and a properly sloped top coat so water actually moves toward the drains instead of pooling.
On apartments along Compton Boulevard and Rosecrans, we regularly find original torch-down that was never top-coated after installation. That’s a 10-year roof that’s been failing for 30. If you see blistering or alligator cracking on your flat section, don’t wait for the next atmospheric river. Get it quoted now.
When Flat Roof Sections Need Full Replacement
If water is already getting inside a unit, or the substrate is spongy underfoot, a patch won’t fix it. Replacing the entire flat section costs more up front but stops the cycle of repeated patches that layering onto a failing membrane guarantees. Fair warning: if the existing roof was never pitched correctly, even a new membrane will pond in the same spots. We correct the slope at replacement so you’re not re-roofing the same problem in five years.
Roof Installation in Compton
Roof installation in Compton for a new construction project or a full tear-off of an original composition shingle roof typically lands between $9,200 and $16,800 for the average one-story stucco ranch on a tight lot in 90221 and 90222. That number assumes architectural shingles, standard replacement decking where needed, and the coastal-spec fasteners and drip edge we specify for every Compton job. Some sections of the city, particularly around the newer infill lots near the Dominguez Channel, run higher because of access and fencing constraints.
Full Tear-Off Versus Re-Cover
The critical decision on a Compton roof installation is whether you re-cover over the existing shingle layer or strip it to the deck. Re-covering saves money now. We generally advise against it on these homes for one reason: you can’t see the decking. On a 1962 ranch off Alondra Boulevard, we pulled off 3-tab shingles that looked tired but serviceable, and underneath we found the original fascia nailer soft where the stucco met the eave. Had we re-covered, that wicking would have continued silently. A full tear-off lets us inspect and replace the deck, set proper ice and water shield along eave gaps, and install the new system correctly.
Why We Specify Coastal-Spec Materials
Compton doesn’t get ocean spray like El Segundo, but the salt-air influence from the South Bay is real enough to corrode standard galvanized fasteners and thin drip edge within a decade. Our standard specified install uses stainless ring-shank nails and a heavier-gauge drip edge sealed at the stucco-to-fascia seam. It adds about $900 to $1,400 on a typical re-roof. The inland-spec version saves that now and fails at penetrations and eave edges within ten to twelve years. We’ll show you both lines on the quote and let you decide. Most customers, once they see the math, choose the coastal spec.
Trusted Brands We Service in Compton
We install and service GAF, CertainTeed, Owens Corning, and IKO shingle lines here in Compton, which means we’re not steering you into one product family because a supplier gave us a better margin. If your HOA or budget calls for a specific warranty tier, we can pull from whichever manufacturer fits: a GAF Timberline HDZ for a steep-sloped 1950s bungalow, a CertainTeed Landmark for a tighter-budget rental property, or an Owens Corning Duration for maximum granule retention on a low-slope ranch. We keep local parts stocked for all four brands so warranty replacements and material callbacks don’t turn into a two-week wait for a truck from a distribution center in Fontana.
See the difference
Before
After
Before
After
Before
AfterCommon Roof Replacement Problems We See in Compton Homes
- Sun-fatigued mineral-surface shingles on low-slope roofs. Decades of uninterrupted South Bay UV bake the granules off, then the asphalt substrate dries and cracks at the drip edge and in valleys. The first winter atmospheric river finds every one of those cracks. We see this on at least half the re-roofs we quote in 90222.
- Water intrusion at the stucco-to-fascia seam. On tight-lot tract homes with shallow eaves, the narrow gap where the stucco wall meets the roof edge is where wind-driven rain gets in. The original builders used minimal overhang to stay within lot-line setbacks. We seal that seam and set ice and water shield along the eave on every replacement we do here.
- Corroded fasteners and thin drip edge. Standard galvanized nails and builder-grade drip edge do not survive Compton’s salt-tinged air over the long haul. We find rusted nail heads and brittle folded drip edge on homes that were re-roofed only a decade ago using inland-spec materials.
- Debris-blocked soffit venting. With shallow eaves and tight lot spacing, leaves and grit pack into the narrow eave gaps, block airflow, and turn the attic into an oven. That heat shortens the life of any shingle we install, which is why we check and clear vent paths on every replacement and recommend ridge venting where the existing system is underperforming.
Pricing for Roof Replacement in Compton, CA
A straightforward architectural shingle replacement on a 1,100 to 1,400 square foot Compton ranch runs $9,800 to $13,500. That’s full tear-off, new synthetic underlayment, stainless fasteners, sealed eave details, and standard deck repairs. If we’re working on a home that needs significant decking replacement, or a flat roof section that has failed, you’re looking at $14,000 to $18,500. New construction roof installation on Compton infill lots runs $12,000 to $21,000 depending on roof complexity and material tier. The coastal-spec upgrade we strongly recommend here adds roughly $900 to $1,400 over the inland-spec bid from a competitor. Call (855) 597-2817 for a free written line-item quote on your specific roof. We’ll show you exactly where the money goes, and why the cheapest bid on a Compton roof is rarely the cheapest roof over 15 years.
We Also Serve Cities Near Compton
Seacrest Roofing covers Roof Replacement work across the South Bay corridor, including East Rancho Dominguez, West Rancho Dominguez, Carson, and Gardena. If your home sits on the border where 90221 meets East Rancho Dominguez, or you’re in Gardena with a similar 1950s tract build, we handle the full lifecycle from inspection through replacement. Learn more about the full scope of our work on the main Roof Replacement hub, or see what we do specifically in Compton and surrounding neighborhoods.
Serving Compton, CA — Our Local Coverage Area
We’re based in the Compton area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Roof Replacement in Compton
The shallow eave detail on 1940s to 1960s stucco tract homes leaves a narrow gap where the stucco wall meets the roof edge, and the original builders did not seal that seam or set ice and water shield along it. Wind-driven rain from winter atmospheric rivers pushes water into that gap, and because the overhang is minimal, the water wicks backward into the fascia and ceiling rather than dripping clear of the wall. Inland homes with wider overhangs and less wind exposure don’t have this failure mode to the same degree. We seal the seam and install ice and water shield along the eave on every Compton re-roof. Call (855) 597-2817 for an exact evaluation of your roof’s eave condition.
Yes, and here’s the honest reason: Compton’s proximity to the South Bay means enough salt in the air to corrode standard electro-galvanized nails and thin drip edge before the shingles themselves wear out. We’ve pulled roofs in 90221 where the shingles had five years of life left but the fasteners had rusted through at the eave and valley penetrations. Stainless ring-shank nails and a heavier-gauge drip edge add about $900 to $1,400 on a typical single-family replacement. The cheaper inland-spec hardware fails at the penetrations within ten to twelve years, and then you’re paying for tear-off labor twice. Call (855) 597-2817 for a side-by-side hardware quote on your roof.
On a standard 1,100 to 1,400 square foot ranch, the coastal-spec upgrade runs about $900 to $1,400 more than the inland-spec bid you’ll get from a contractor who doesn’t account for South Bay salt air. That buys stainless ring-shank fasteners, heavier-gauge sealed drip edge, ice and water shield along eave gaps and valleys, and a properly sealed stucco-to-fascia transition. The inland-spec saves that amount today and typically needs full re-fastening or partial replacement within ten to twelve years, at which point the labor cost alone exceeds the original savings. We show both line items on every Compton quote. Call (855) 597-2817 for your free estimate.
If your roof pitch is below 2:12, standard architectural shingles are the wrong product and will void the manufacturer’s warranty. Most of the 1940s to 1960s tract homes in Compton have slopes between 3:12 and 4:12, which shingles handle fine if the eave details are correct. But sections that are genuinely low-slope, like carport additions or enclosed porch roofs, need either a modified-bitumen membrane or a standing-seam metal system. We’ll tell you exactly which sections of your roof fall into which category during inspection, and we’ll quote them separately so you’re not paying for a flat-roof system where shingles are perfectly appropriate. Call (855) 597-2817 to schedule your inspection.
Start by confirming both bids include a full tear-off to the deck, not a re-cover. Then check the fastener spec: if it says electro-galvanized or standard drip edge, that’s the inland-spec hardware that fails early in Compton’s salt air. Compare the eave detail: does the bid line-item mention sealing the stucco-to-fascia seam or installing ice and water shield along shallow eave gaps? If not, ask why, because that’s the #1 failure point we see on tract homes here. Look at the shingle brand: if the contractor only offers one brand, that’s a supply agreement, not a recommendation. Finally, compare decking repair allowances. We quote 2 sheets of plywood as a standard allowance on Compton re-roofs based on what we typically find. If a bid includes zero decking allowance, it’s likely to hit you with a change order once the old roof comes off. Call (855) 597-2817 and ask us to walk you through the line items on any competitor’s bid. It costs you nothing and makes the comparison honest.
Written by Noel Chambers, Owner at Seacrest Roofing, serving Compton since Seacrest opened its doors out of Downey, CA.